Once you've found a hose, prepare it by flushing the hose through for a few moments to make sure you have clean water. ![]() Check that all hardware such as nuts and bolts are firmly in place, then inspect belts, pulleys and safety guards too. ![]() A good way to check the valves is to manually operate them to make sure they function properly. ![]() Drain plugs will need to be checked for issues such as re-tightening. If the system has been shut over winter, it's even more important to do these checks thoroughly. You'll need to pay attention to fittings such as piping for damage such as cracks. Make sure you inspect the pump thoroughly. You'll need to access the pump system, so the next step is to find a plumbing fixture that will help you get access - this is usually the fixture nearest the water tank, but on a pool pump, it'll be the strainer basket. Make sure that the electrical power is turned off by checking the breaker panel - you may even want to take a look at the base of the pump to double check. Never leave a pump plugged in while you're working on it. We've put a quick guide together to help you through the basic steps of priming your water pump. This means that water will need to be flushed back into the pump and forced through - this creates the pressure it needs to begin pumping again. To get it working again, your water pump will need to be primed. ![]() If you've turned your water pump off over the winter months, chances are that it has run out of pressure.
0 Comments
Leave a Reply. |